Dynamite - DYNR0100
This small, MCU-controlled POWER SWITCH uses a simple push button to eliminate problems associated with the intermittent contact of an ordinary mechanical switch.
The sealed plastic unit can be mounted to your model’s transponder mount or another easy-to-reach spot using double sided tape. An additional bottom mount is included.
The switch features a LiPo mode, which will auto detect low LiPo voltage and cut off power to protect your LiPo from over discharging. If other safeguards are in place, this can be turned off when using a NiMH/NiCd battery.
The power switch also indicates remaining battery capacity
NiMH/NiCd Battery Pack
- To turn ON NiMH/NiCd, press and hold the button for 1 second. The PWR LED will turn on.
- To turn OFF, press and hold the button until all LEDs turn off.
Tip:
The PWR LED displays the remaining battery capacity when switched on.
Remaining Battery Capacity
- Green 80–100%
- Orange 60–79%
- Red 20–59%
- Red Blinking <20%
LiPo Battery Pack
- To turn ON LiPo, press and hold the button for a minimum 3 seconds. The PWR LED and LiPo LED will turn on.
- To turn OFF, press and hold the button until all LEDs turn off.
Tip:
The PWR LED displays the remaining battery capacity when switched on.
Remaining Battery Capacity
- Green 80–100%
- Orange 60–79%
- Red 20–59%
- Red Blinking <20%
SPECIFICATIONS
- Current: 10A
- Battery Mode: NiMH/NiCd and LiPo
- Low Voltage Protection: 6.2V (LiPo mode only)
- Weight: <7g
- Operating Temperature: 0–50°C
- Input Voltage: 4–12V